|
Overview:
The AGB-O-Matic is
used for filling and de-aerating a water cooling system. The use of this
device is very simple: You just need to plug it onto the EHEIM pump. Then,
the pump can suck in the fresh water directly and absolutely free of blow
holes.
Despite of the slim
design of 50x56x120 mm, the AGB-O-Matic provides a huge filling volume.
The tank is leakproofed which makes it possible to transport the device
easily.
After installing
the AGB-O-Matic, the water cooling system is filled though the aparture
at the top (see picture).
Details:
The
AGB-O-Matic is optimized for the Eheim pumps 1046 and 1048. It consists
of glass fibre reinforced plastics.
As standard,
the runback flow is equipped with one 8x1 screw connection. The 1/4 inch
screw thread makes it possible to use other connectors and therefore to
combine the AGB-O-Matic with tubes that have other diameters.
The
highly efficient and tricky runback flow and the well constructed flow
geometry are the reason why the pump can suck in the water free of blow
holes. Therefore, de-aerating the system is done very fast.
Technical
facts:
- Weight: 110 g
Material: Glass fibre reinforced plastics
Dimensions (without the pump): 50x56x120 mm
Fits with Eheim 1046 and 1048
Equipped with one 8x1 screw connection (straight)
Installation:
The AGB-O-Matic is
installed in the same way like a conventional reservoir. Only for the
first installation, you need to dismantle the pump (see picture on the
left-hand side at the bottom of this page) and to plug the tank onto the
connection of the pump by turning the reservoir clockwise as far as it
will go. It helps if you wet the double seal that you can find within
the reservoir a little bit. The tank (the picture on the right-hand side
shows the "little brother" of the AGB-O-Matic) has to face the pump. The
double seal connects the tank absolutley leakproof with the pump. |
watercooled cases
complete kits
